The W24Q128 is a good development
![oki doki :okidoki;](./images/smilies/Finger_fing32.gif)
Is this the correct procedure if a new blank Q128 is installed and I have a Raspberry Pi for unbricking?
1. Desolder Q32
2. Solder new Q128
3. Copy recovery.bit (from download attachment 1st post viewtopic.php?f=37&t=774) to Raspberry Pi /boot
4. Copy 16mb FLASH.ZX1 from a few posts down - download/file.php?id=1095 to blank ZX-UNO SDCard (FAT/FAT32?)
5. Follow 'Unbricking the ZX-Uno with Raspberry Pi' guide from User Manual:
* run various Raspberry Pi commands for jtag then,
* connect ZX-Uno to Raspberry Pi GPIO
* turn on ZX-Uno (with SDcard featuring FLASH.ZX1 (16mb file)
* type - pld load /boot/recovery.bit once Raspberry Pi has finished you flash the FLASH.ZX1 with ZX-Uno menu
6. Turn off Raspberry Pi and ZX-Uno.
7. Turn on ZX-Uno and enjoy lots and lots of Core slots
![maestro :maestro:](./images/smilies/anim_37.gif)
Thanks