Re: Soporte para Flash W25Q128
Publicado: 23 Feb 2017, 02:11
Yo tambien he actualizado la flash y es una pasada tener todos los cores disponibles dentro del zxuno. Como dice ManuFerHi, con aire caliente y pasta se hace en un momento.
Forum to discuss about the ZX-Uno project
https://www.zxuno.com/forum/
Yes.bakoulis escribió:If I order one from here, is the correct type of chip?
http://www.ebay.com/itm/1x-W25Q128FV-W2 ... Sw9mFWImt-
carmeloco escribió:Yes.bakoulis escribió:If I order one from here, is the correct type of chip?
http://www.ebay.com/itm/1x-W25Q128FV-W2 ... Sw9mFWImt-
brick board! you need a flash chip with a preinstalled firmware or a system recovery like cable xilinx, altera, RPi, etc.bakoulis escribió:Just ordered. A last question.
When de-soldered the old chip and soldered the new one, can I flash the board first time from SD, or is like a bricked board?
ManuFerHi escribió:brick board! you need a flash chip with a preinstalled firmware or a system recovery like cable xilinx, altera, RPi, etc.bakoulis escribió:Just ordered. A last question.
When de-soldered the old chip and soldered the new one, can I flash the board first time from SD, or is like a bricked board?
Some programmers, don't have the QE option. I have too a Genius G540, and don't has the QE option.BCH escribió:I've bought something like this:
http://www.ebay.es/itm/CH341A-24-25-Ser ... Sw2GlXIKDG
The only problem is that the software does not have the option to set the QE flag (at least I could not find it).